![]() You can now adjust the middle of your heading by dragging the marker on the top of the ruler. Move your cursor to the end of your heading. Select "Strikethrough." Hit "Tab" key once. Position your cursor before the beginning of your heading. Once you have the mark there, drag it to the marker that designates the right side of the printable area (4). Place your upside-down "T" on the lower part of the ruler somewhere in the middle (you can easily adjust it later, so an approximation would work just fine for now) (3).Ĭlick the corner with funky shapes once more, you should see the mirrored "L", now click on the lower part of the ruler again, closer to the right border of the printable area. Make sure your "L" is on top of the bottom piece (2).Ĭlick the corner with funky shapes once, your selection should change to the upside-down "T". Find the tab marks on the left of the ruler (you drag them to adjust the left alignment). Once you see it there, you can drag it wherever you need it. Make sure it is displayed and click on the lower part of the ruler until you see the same shape show up on the ruler. The one that's displayed should be the "L" looking, when you hover your mouse over it, it says "Left Tab" (the one that's on the picture is the Right tab). ![]() In the top left corner of the document area (below the ribbon), there is a little square with funky signs that change if you keep clicking on them (1). Type "Heading" on the line where you need it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |